first 3d-printed rocket’ launched in third attempt, fails to reach orbit.
Friends, you must have heard the name Terran 1, which was the world's first 3D printed rocket, which was to be launched at the Florida launch site on Saturday from 1 pm to 4 pm, which ultimately failed.
 |
| Credit :- relativity |
Who made terran 1 rocket:-
This rocket was made by Arrow Startup Relativity Space based in California which failed and where is the manager of relativity Space organization that our teams made an amazing effort in ostensibly there was a lot of hope to send our Terran 1 but we Will continue this effort and take this rocket far ahead.
what were the features of terran 1 ?:-
The Terran 1 didn't have a payload system, it was just an experiment to see if it could handle the load and trouble.
In the future there is a plan to send with a weight of 1 thousand 250 kg and its quality is that 85 percent of it is made with 3D technology, in this some material is made by recycling, due to which its cost is also less. Terran 1 diameter is 7.5 feet. And its length is 110 feet. A total of 85 percent alloy steel was made of the engine of this rocket. This is the first rocket of 3D technology.
This rocket has an eon engine which runs on methane, liquid nitrogen and liquid nature fuel which is very modern.
The Relativity Organization organization says that this will be the world's first rocket that will travel to space by natural fuel and it will save money. Elon Musk has the right that this technology will be used for urbanization in Mars, which is very beneficial.
What is the 3D technology ?:-
You must have seen a 3D film, for which a glass is needed, which has length, width and height, this is called 3D, many things made through it can be made, houses can also be made from it, which many companies use this technology. To make many things, it is said that this future all the houses will be made by this technology.
Post a Comment